Model
6mm Knob using Rivet-Nut Insert
#knob
#nut
#clip
#phone
#bolt
#jeep
#gps
#rivet
#retainer
#6mm
#jeepjk
#jeepwrangler
#mcmaster
#mcmastercarr
#cert
#rivnut
#nutsert
#bulletpointmounting
#netcert
Description
6mm Knob using Rivet-Nut Insert, Nut-Sert, or Nut-Cert
I wanted some knobs that matched the blue CF arm.
https://www.bulletpointmountingsolutions.com/
Here is my fix.
I used 3D Fuel PRO-PCTG (Cobalt Blue)
https://www.3dfuel.com/products/pro-pctg-cobalt-blue-1-75mm
McMaster-CARR Rivet Nut (QNTY-1)
https://www.mcmaster.com/95105A183/
McMaster_CARR 6mm SS Bolt 30mm Long (QNTY-1)
https://www.mcmaster.com/91287A903/
Added in Optional_RIV-NUT-CAP_v3. This just fills the hole at the end of the RIV-NUT and is purely cosmetic. It is a snap it fit.
Just added a bolt retainer clip. (pictured below). For those times when you are trying to remove or add a device by tightening the ball with the clamshell halves. Takes care of the pesky bolt jumping out to the ground.
Completed and installed parts.
NOTE - Rivet-Nut is used as an insert for this product using a soldering iron at 330 deg C to melt it in. It is not compressed.
License
